Elitegroup H70 - Manual (Page 40)

28
Beeping
accelerates Battery Low Low: Indicates that there is 1 to 2
minutes of battery charge remaining. Save your
work and turn off the computer, or connect the AC
adapter.
When there is only one minute of battery charge remaining, the
computer will suspend to the HDD and power off. You should
connect AC power and resume to save your work.
Small Battery for the Real Time Clock
There is a small built-in battery pack that supplies power to the
system in order to maintain certain system information while the
power is off. If the computer is left without a power source for long
period of time, this battery will be exhausted and system
information will be lost.
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries
according to the manufacturer's instructions. Never remove the
battery pack while the power is on as this may result in data loss
when the system loses power.
B ATTERY C ALIBRATION
The purpose for this process is to provide a longer battery life for
your system battery pack.
1.
Turn on the computer, when the text appears, press [Del] or
the [Delete] key until the system enters the BIOS Setup screen,
you may now make the necessary changes.
2.
Press the Î arrow key until it reaches the “Exit” menu screen.
Again press the Ð arrow key and select the “Battery
Calibration” item.
Press the [Enter] key and disconnect the AC adapter then
press the [Y] key until you hear continuous battery low-low
warning beeping sounds.
The system will be fully discharge and shutdown completely.
3.
Connect the AC adapter and let the battery fully recharge. The
“Battery Charge LED” of the computer will light indicating it is
in charging status.
4.
When the battery charge LED turns off will indicate the system
is fully charged.
5.
Repeat step 1 to 4 once again.
6.
The battery is now fully calibrated.