HATZ Diesel 1B50W - Manual (Page 9)

3.2. Transport
A suspension lug „8“ is provided as
standard equipment, so that the engine
can be lifted safely, chap. 2. It is not suitable
or approved for lifting the complete equipment
to which the engine is attached.
3.3. Notes on installation
If you have an engine which is not yet installed
in a machine and still has to be installed, make
sure that the Assembly Instructions for HATZ
Diesel Engines are complied with prior to instal-
lation. These Assembly Instructions contain im-
portant information about safe assembly of the
engine and are available from your the HATZ
service center in your area.
Pending complete installation, the engine
must not be started !
Moreover, we would like to point out that in this
case, commissioning of the machine is also pro-
hibited until it has been verified that the machine
into which this engine is to be incorporated
complies with all the safety precautions and reg-
ulations provided by law.
Refer also to the Declaration for Incorporation
at the end of these Operating Instructions.
2
The permitted loads and elements
on the speed adjusting lever and the
engine shutdown pin should be observed as an
excess can lead to damage to the contacts and
inner governor parts, Fig. 2.
3.4. Load on engine
Operating the engine for a lengthy period off-
load or at very low loads can affect its running
quality. We therefore recommend a minimum
engine load of 15 %. If operated at such low
loads, it is best to operate the engine at a signifi-
cantly higher load for a short period before
switching it off.
3.5. Type plate
3
The type plate is placed on the noise insulating
hood (Fig. 1) and includes the following engine
information:
➀ engine type
➁ code (only for special equipment)
➂ engine number
(also stamped on crankcase, Fig. 4)
➃ max. engine speed.
For any offer as well as spare parts orders it is
necessary to mention these data (also see spare
parts list, page 1).
➀ ➁
➂
➃
7