Hired-Hand Light Traps: Light Trap Adapter Kit - Manual

1. The Light Trap Adapter consists of a galvanized
steel top, bottom, and two side pieces which must
be attached to the fan. Lay fan flat on ground, blade
side facing down.
2. Remove screen by bending retainer clips as open
as possible to keep the clips from interfering in later steps.
To bend the clips, push a punch or screwdriver through
holes (See Figure 1).
3. Add adapter sidewall pieces as shown above
for a fan (Figure 2). You will use the 1/4 x 3/4
inch bolts and lock-nuts provided. On 36" fans
built before 1/95, you may need to drill the middle
hole on the sides. Do not tighten nuts until
step four.
4. Attach the two metal stops to the Fan Top and
Bottom, respectively. Then add the Top and
Bottom adapter pieces to the assembly.
(See Figure 3)
Light-Trap Adapter Kit Light-Trap Adapter Kit
HIRED-HAND, INC. HIRED-HAND, INC. 1733 Co Rd 68 Bremen, AL 35033 Phone 205-287-1000 Fax 205-287-2000
Manual Part No. 4801-2983 Manual Part No. 4801-2983
Figure 1
Assembly
Note: Note:
On the belt drive fan, be sure that On the belt drive fan, be sure that
the the motor is positioned toward the motor is positioned toward the
bottom of the fan. bottom of the fan. See Figure 2. See Figure 2.
Figure 2
Top
Bottom
Note: The edges of the
top and bottom pieces
of the side pieces.
Figure 3
Fan Top
Fan Bottom
Note: Tighten all nuts after all pieces are
loosely mounted to the fan housing.
Important! Install metal
flange pieces, which
serve as stops for
the Light Trap,
to Top and
Bottom.
Bottom
Top
Be sure that the fan is not plugged into any power source when removing
fan guard. Always double check power sources.
Warning!
Instructions Continued On Back