Hired-Hand Mega Flow SlantWall Fans: Fan Motor Start Capacitor User Manual
Replacement instructions, Warning, Description
REPLACEMENT INSTRUCTIONS
3017-3101 Fan Motor Start Capacitor
HIRED-HAND MFG., INC. • 1733 County Rd 68 • Bremen, Alabama 35033 · Phone 256-287-1000 • Fax 256-287-2000
Part No. 4802-5123 rev 5-09
Page 1 of 2
WARNING!
1. Only qualified electrician personnel familiar with the
construction and operation of this equipment and the hazards
involved should install and/or service this equipment. It is
important that all standard electrical codes be observed when
wiring the fan. Read and understand all instructions and
diagrams before proceeding. Failure to observe this
precaution could result in equipment damage, severe bodily
injury, or loss of life.
2. Disconnect power source before installing or servicing fan.
Failure to disconnect power source can result in property
damage, serious injury, or death.
3. When connected to an automatic controller, FAN MAY
START AT ANY TIME.
4. IMPORTANT! Before Operating Fan, Inspect Fan For any
Object That May Obstruct Blade Rotation.
5. When this fan is used in a life support ventilation system
where failure could result in loss or injury, the user should
provide adequate backup ventilation or accept the risk of such
loss or injury.
6.
Discharge capacitor appropriately prior to handling.
Tools Required
¼” Nut Driver
Replacement Part Number
3504-7102
Start Capacitor for WEG 3017-3101 Motor
DESCRIPTION
The replacement instructions in this document provide
details for replacing the fan motor start capacitor (3504-
7102) specifically for the WEG fan motor (3017-3101).
IMPORTANT!
The start capacitor may be located on either
side of the fan motor. Ensure that the
capacitor being replaced is Black in color.
Fan Motor
(Mounted Installation
Not Shown for Clarity)
Figure 1: Fan Motor Break-down View
Run Capacitor
Color = Light Gray
Foam
Cover
Gasket
Start Capacitor
Color = Black
Gasket
Foam
Cover
Screw
Screws
IMPORTANT!
The start capacitor may be located on either side
of the fan motor. Ensure that the capacitor
being replaced is Black in color.