Hired-Hand Mega Flow SlantWall Fans: Butterfly Cone Fan Unassembled - Manual (Page 8)

Part No. 4801-5327 Rev 6/07 Mega-Flow Butterfly Cone - Unassembled Page 8 of 12
Arrange panels for assembly with pilot
hole on each panel facing upward.
Install #14 x1/2"
sm screw
Install #14 x1/2" sm screw
Pilot hole faces upward
Pull flanges
together to
align mounting
holes
Mounting
hole for
wire guard
Joints
Slot for mounting
top of cone to fan
housing
6. Assemble Cone
17A. Arrange panels contacting as shown in Figure 6. NOTE: The pilot hole pointing upward. Refer to Figure 6 Inset B.
17B. For each panel, slide panels together. See Figure 6 Inset A.
17C. Align holes of flanges. See Figure 6 Inset A. Install sheet metal screws as shown in Insets B and C.
WARNING!
During Cone Installation Be Sure That Fan Motor Is Not Plugged Into Any Power Source.
Always Double Check Power Sources.
!
Packing List For One (1) Cone/Inlet Kit
Part Number Description Quantity Part Number Description Quantity
0404-8253 Cone Sections 4 6403-7606 Door Stop Rod 1
6403-3150 Butterfly Damper Assy. 1 1001-1446 ¼" x20 Nuts 4
0404-1424 3/8"-16 x 1-1/4” Cap Screws 7 1004-9045 #14 x ½ screws 4
1001-1457 3/8"-16 Nuts 7 1004-6013 ¼"-20 x 1" Screws 4
6403-0147 PVC Coated Cone Guard 1 1003-6027 3/8" Washers 10
6450-7100 Inlet Wire Screen 1 0404-8252 Cone Bracket 4
0404-8254 Inlet Top/Bottom 2 1005-1464 Rivets 12
0404-8255 Inlet Sides 2 6403-3160 Cone Support Bracket 1
Figure 6 - Assembly & Installation of Cone
Inset A
Inset C
Inset B
Mounting holes for
Damper Ring
Tools Required
7/16 in. (11 mm) Wrench 9/16 in. (14 mm) Socket ½”socket Cordless drill Ratchet
9/16 in. (14 mm) Wrench 3/8”, 5/16”, 7/16” Nut Driver 7/16 in. (11 mm) Socket Rubber Mallet Marker or Scribe
Phillips head screwdriver 3/8”, 5/16”, 7/16” Nut Driver 7/16 in. (11 mm) Socket Rubber Mallet Marker or Scribe