Hired-Hand Super-Savers (Forced Air Heaters) XL: Direct Wire Flame Probe Kit - Manual

Direct Wire Flame Probe Kit
For Super-Saver XL Heater
HIRED-HAND MFG., INC. • 1733 County Road 68 • Bremen, Alabama 35033 USA• Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4802-5082 rev 3-06 Page 1 of 2
WARNING
Disconnect All Electrical Power Sources And Turn Off
Gas To Super-Saver Heater Before Conducting
Modifications!
WARNING
DO NOT perform modifications while unit is HOT!
Allow unit to cool!
15 mm Open-End Wrench Wire Cutter
Needle-Nose Pliers
(Med-Lrg)
Philips Screw-Driver
Wire Pliers Flat-Head Screw-Driver
INSTRUCTIONS:
1. Disconnect electrical power and turn off the gas to the
Super-Saver Heater.
2. Disconnect the quick-connect receptacle to the
internal enclosure. Refer to Figure 1.
FIGURE 1 FIGURE 2
3. Loosen the receptacles two philips-head screws and
slide the braided wire sleeve away from the
receptacle. Refer to Figure 2.
4. Cut the yellow wire approximately 2” below the
receptacle, reassemble the sleeve and receptacle,
and reconnect to the enclosure. Refer to Figure 3.
FIGURE 3 FIGURE 4
5. Pull the yellow wire out of the opposite end of the wire
sleeve where the cord-set exits the heater.
6. Use a flat-head screwdriver to remove the internal
enclosures knock-out on the left side. Refer to
Figure 4.
7. Use needle-nose pliers to remove the CENTER
Yellow wire (FSI connection) from the electronic
module terminal block. Remove by pulling
STRAIGHT OUTWARD. Refer to Figure 5.
FIGURE 5 FIGURE 6
8. Cut this same Yellow wire approximately 1” from the
quick-connect male connector and discard this wire.
DO NOT CUT OTHER WIRES! Refer to Figure 6.
9. Reference the included parts list for a complete list of
components and descriptions. Refer to Figure 7 and
Table A.
FIGURE 7
TABLE A
6650-0400 Modification Kit Parts List
Part # Description Qty.
1901-6490 Replacement Wire Assy. 1
3006-0137 IDC (Insulation Disp. Conn.) 1
1013-5003 Nylon Fitting, Liquid-Tight 1
1044-2477 Tubing 2”
1003-5014 Flat Washer, 7/16 2
1007-2299 Cable Tie 2
1001-0108 Nylon Nut, Liquid-Tight 1
! !
Quick Connect
Receptacle
Wire Sleeve
Knock-Out
Washers
IDC
Nylon Nut
Hose
Cable Ties
Wire Assy.
Nylon Fitting