Hired-Hand Polar Cool: Wall Mount Kit - Manual

RollSeal, Inc. • 1751 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-7000 • Fax 256-287-7010
Sheet Part No. 4801-5208 rev 1-07 Page 1 of 4
Tool Required
9/16” Wrenches Level Wall Fasteners Tape Measure Cutting Tools
Description
This kit mounts the PolarCool Cabinet on a vertical wall. This manual covers the Wall Mount Kit Part No.
6450-9952.
Directions
Directions for
Installing PolarCool Wall Mount Kit
1
From Figure 2 identify the Right
and Left Side Brackets and assemble with
hardware as shown in Figure 3.
2
See Figure 3. Assemble the
Front Support Bracket, the Top Angle
Bracket and the Bottom Support Bracket
with 3/8” cap screws and lock nuts.
NOTE1: The Front Support Bracket fits
inside the Side Brackets.
NOTE 2: Do not install the Front
Adjustable Bracket until the PolarCool
unit is lifted in place.
3
See Figure 1. Cut hole in wall
measuring 43” (1.09 m) by 43" (1.09 m). A
wall girt should be flush with the bottom of the
wall opening. The bottom of the opening
should be a minimum of 5 feet (1.52 m)
above the floor. An additional wall girt must
be present within 5 feet (1.52 m) of the bottom
of the opening.
43”
43”
Wall girt flush with
bottom of opening.
5’ min. to
floor
A wall girt must be within
5’ (1.52 m) of bottom of
opening.
Figure 1 -
PolarCool Opening Requirements
Figure 2 – Assembled Wall Mount
S Warning!
Disconnect All Electrical Power Sources Before Installing the Wall Mount Kit.
! !