Hired-Hand Mega-Cool: Mega-Cool Pad Extender Kit - Manual

Hired-Hand Mfg., Inc. • 1733 Co Rd 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Sheet Part No. 4801-5136 Rev. 12-04 Page 1 of 5
Tools Required
PVC Piping Glue Level Circular Saw Wrench Set Drill
PVC Piping Cutter Chalk Line Hammer Socket Set 5/16” and ¼” Nut Driver
Description
This kit extends the evaporative cooling panels away from a building to allow room for an existing curtain
system. Shown below is a side view of a completed Mega-Cool installation using the Pad Extender Kit. In
addition to these instructions, the installer will also need the Hired-Hand Mega-Cool Manual (Part No. 4801-
5120).
Directions for Installing
Mega-Cool Pad Extender Kit
S Warning!
Disconnect All Electrical Power Sources Before Installing Pad Extender Kit
!
"A"
Opening In Wall
System Size
4 foot 48 in. (1.2 m)
5 foot 60 in. (1.5 m)
6 foot 72 in. (1.8 m)
"B"
Overall System Height
System Size
4 foot 66-7/8 in. (1.7 m)
5 foot 78-7/8 in. (2.0 m)
6 foot 90-7/8 in. (2.3 m)
"C"
Curtain Opening
System Size
4 foot 41 in. (1.0 m)
5 foot 53 in. (1.3 m)
6 foot 65 in. (1.6 m)
"B"
"C" "A"
Ope
n
in
g In Wall
Curtai
n O
p
eni
n
g
4.5 in. (11.43 cm)
3.5 in. (8.89 cm)
14 in.
(35.5 cm)
Pad
Curtain
Flashing
Bottom Extender
Bracket
Pipe Support
Bracket
Top of flange
Top Extender
Bracket
NOTE: See Mega-Cool manual (4801-5120) for framing details.
This figure shows two 2 x 4 boards for supporting curtain.
Other schemes of curtain support may use only one 2 x 4
board at either top or bottom of opening.
2 x 4
2 x 4
W
o
od Or
Co
ncr
e
te
W
a
ll