Hired-Hand PowerTrak - Manual (Page 9)

Part No. 4801-0154 Rev 8-07 PowerTrak Page 9 of 22
10. If for any reason it is necessary for you to mount the PowerTrak horizontally, punch the
"Knock-outs" and run the cables straight through the top of the machine. It is very important to
loop the cable around a needle bearing pulley as seen below to ensure even weight distribution
on the Load Block. This pulley also acts as a spacer to keep the cables straight.
11. Hookup electrical wiring as shown in the wiring diagrams in the back of this manual. Note:
All wiring must comply with all National and Local Electric Codes.
12. With the controller in manual mode, close the machine fully. Then take up the slack on the
cabling with the manual winch. (Note: With the PowerTrak you have the ability to adjust the
lower limit switch setpoint, however, our factory setting should be sufficient for most
applications.)
13. Next, open the curtains with the manual controls. When the curtain reaches the bottom of the
opening, or whichever point you choose, stop curtain motion, and set high adjustment collar
(near the top of the machine) on limit switch guide rod to this point. There is a 3/32" allen
wrench included in the kit bag for loosening and tightening the setscrew in the collar.
14. Attach a small cable clamp to the cable near the hand winch as a reminder not to wind the
cables past this point.
15. Replace the door to protect the machine from the elements.