Operation – Kushlan Products KPRC160 User Manual

Page 4

Advertising
background image

Slip/Trip/Fall is a major cause of serious injury or death. Be aware of uneven or slippery work surfaces.

Exercise care when working in the vicinity of unprotected holes or excavations.

OPERATION

Pre start-up inspection

The following Pre-start-up inspection must be performed before the start of each work session or after

every four hours of use. Which ever is first. If any fault is discovered, the compactor must not be used

until the fault is rectified.

1. Thoroughly inspect the compactor for signs of damage. Check components are present and secure.

Pay special attention to the belt drive safety guard fitted between the engine and the vibrator unit.

2. Check the engine oil level and top up as necessary

3. Check the engine fuel level and top up as necessary

4. Check for fuel and oil leaks

Start and stop Procedure for Petrol Engine

1. Open the fuel tap by moving the fuel ON/OFF lever fully to the right.

2. If starting the engine from cold, set the choke ON by moving the choke lever fully to the left. If

restarting a warm engine, he choke is usually not required. However, if the engine has cooled to a

degree, partial choke may be required.

3. Turn the engine ON/OFF switch clockwise to the "1" position.

4. Set the throttle to the idle position by moving the throttle lever fully to the right. Do not start the engine

on full throttle, As the compactor will vibrate as soon as the engine starts.

5.Taking a firm hold o the control handle with one hand, grasp the recoil starter handle with the other.,

pull the recoil starter until engine resistance is felt. Then let starter return.

6. Taking care not to pull starter's cope fully out. pull the starter handle briskly.

7. Repeat until the engine fires.

8. Once the engine fires gradually, set the choke lever to the OFF position by moving It to the right.

9. If the engine fails to fire after several attempts, follow the trouble-shooting guide on page 5.

10. To stop the engine, set the throttle to idle and turn the engine ON/OFF switch anticlockwise o the "0"

position.

11. Turn the fuel off

Advertising