Lincoln Electric IM306 IDEALARC DC-600 - Manual (Page 19)

B-3 OPERATION B-3
IDEALARC DC-600
Duty Cycle
50%
(Based on 10 min.)
750
680
600
44
44
44
50/60
50/60
50/60
60%
(Based on 10 min.)
100%
Amps Volts Hertz
• Auxiliary power source to provide 115-volt AC
power (1000 VA) to wire feeding equipment.
• Multi-functional terminal strip for easy connection
of wire feeding control cables and switching
between CV Innershield and CV Submerged Arc
welding when using the Dual Process or Dual
Procedure Kits.
• Recessed output terminals to avoid any person or
object from accidentally coming into contact with
the output terminals and labeled positive and neg-
ative for easy identification.
• Thermostatically protected power source.
• Electronic protection circuit to protect power
source against overloads.
• Input line voltage compensation to provide an
essentially constant output.
• SCR electronically controlled welder output pro-
vides extra long life, especially for highly repetitive
welding applications.
• Three circuit solid state control system provides
maximum performance and circuit protection.
• Low profile case provides maximum use of space.
• Convenient access to all controls.
• Output lead strain relief loops to prevent terminal
and cable damage.
• Easily removed case side, even when stacked.
• Outdoor operation because enclosure is designed
with air intake louvers that keep dripping water
from entering the unit. Transformer, SCR bridge,
and choke have special corrosion resistant paint
for added protection.
WELDING CAPABILITY
The IDEALARC DC-600 has the following duty cycle ratings:
If the duty cycle is exceeded, a thermal protector will shut off the output of the machine until it cools to the normal
operating temperature.
_____________________________________
_____________________________________