Arlington TV BRIDGE TVBR2505K - Manual (Page 2)

TV Bridge ™
Easy Installation in Existing Walls
1 Stauffer Industrial Park
Scranton, PA 18517
800/233.4717
Fax 570/562.0646
www.aifittings.com
www.arlnew.com
www.arlingtonlowvoltage.com
Arlington
Components are not energized until the flexible cord is plugged in.
Do not plug in until all other wiring is complete.
1 Locate wall studs to position TV Bridge™ between studs.
2 Position the upper box behind (or close to) the installed TV
bracket. Position lower box within 3-1/2 ft. of the existing
receptacle or power conditioner that will power the installation.
Install upper box and lower box in the same stud cavity.
3 Pull a length of NM cable long enough to reach both boxes. Pull
low voltage, coaxial, speaker wires, etc. before installing the boxes.
4 Install NM
cable
through
the
installed
cable
connector.
Attach the boxes securely to the
wall by tightening the two wing
screws.
5 Wire the duplex receptacle and
install it in the upper box.
6 Install LPCG50W cord grip onto
the flexible cord, then install
into the KD4550 using supplied locknut.
7 Connect the cord conductors to corresponding conductors of NM cable
installed in the lower box. Install wire nuts.
8 Install KD4550 assembly to the lower box. Mount the CED13 cable
entry device or CED1 entrance hood to the low voltage sides of both
boxes (machine screws supplied).
9 Install cover plates.
10 Connect TV power cable to the installed duplex outlet
in the upper box Make low voltage connections.
Flat
screen
TV
Note:
- This product is not designed to be an extension
of a structure’s hard wiring.
- Components are not energized until the flexible
cord is plugged in. Do not plug in until all other
wiring is complete.
Distributed by
Patents pending
TVBR2505K 0410/15M
©
2
0
1
0
A
rli
n
g
to
n
I
n
d
u
st
rie
s,
I
n
c.
No messy
wires running
down the wall
LPCG50W
KD4550
Flexible
cord
Wires stay
hidden behind
wall
CED13
CED1
Includes (2) recessed boxes with trim plates and installed NM
cable connectors, (2) duplex covers, wire nuts, tamper-resistant
duplex receptacle, installation screws, LPCG50W cord grip,
4 ft. cord, KD4550 and The SCOOP™ (2) CED1 entrance
hoods, (2) CED13 cable entry devices.
CATALOG UPC/DCI/NAED DESCRIPTION UNIT/STD
NUMBER MFG #01 8997 PKG
TVBR2505K 09658 TV Bridge™ 1
TVBR2505KGC 09108 TV Bridge™ 1
with ground clip
(for Canada)
C
NEW!