Lincoln Electric IM615 K1614-2,-3 MAGNUM 250 NR GUN & CABLE - Manual (Page 10)

B-1 INSTALLATION
MAGNUM® 250 NR
B-1
Read this entire installation section before you
start installation.
SAFETY PRECAUTIONS
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts
such as output terminals or
internal wiring.
• Insulate yourself from the work
and ground.
• Always wear dry insulating gloves.
------------------------------------------------------------------------
Only qualified personnel should install, use or
service this equipment
CONNECTOR KIT INSTALLATION TO GUN
CABLE
The Magnum® 250 NR cables are shipped as generic
assemblies and must be assembled with a K466 con-
nector kit (See REPLACEMENT PARTS section Chart
A for proper kit).
K466-1& -8 INSTALLATION (For Lincoln Feeders)
a. Remove brass cable connector and insulation tube
(see Figure 1) from the K466-1 kit. Slide the insula-
tion tube onto the connector from the threaded end
and screw it onto the feeder end of the gun cable.
Tighten the connection with the wrench provided.
b. Attach the round connector of the gun control cable
provided to the trigger connector on the front of the
Lincoln feeder. (NOTE: Both the plug and socket are
keyed and must be properly oriented.)
c. The gas nipple and tube are not needed.
K466-2 INSTALLATION (For Tweco Adapted Feeders
and Lincoln -10 Series Feeders)
a. Remove brass cable connector (see Figure 1) from
the K466-2 kit and screw it onto the feeder end of
the gun cable. Tighten the connection with the
wrench provided.
K466-3 INSTALLATION (For Miller Feeders; i.e.
Millermatic 200, Cricket, S-32P, 54D...)
a. Remove brass cable connector (see Figure 1) from
the K466-3 kit and screw it onto the feeder end of
the gun cable. Tighten the connection with the
wrench provided.
b. Attach the round connector of the gun control cable
provided to the trigger connector on the front of the
Miller feeder.
K466-4 INSTALLATION (For Hobart Feeders; i.e. 27...)
a. Remove brass cable connector (see Figure 1) from
the K466-4 kit and screw it onto the feeder end of
the gun cable. Tighten the connection with the
wrench provided.
b. The gas nipple and gas tube are not needed.
c. Attach the phone plug connector of the gun control
cable provided to the trigger connector on the front
of the Hobart feeder.
WARNING