LT Security LTD2516HE - Manual (Page 21)

Digital Video Recorder User Manual version 1.0
21
4.5.4 Other alarm
Step1: enter into system configuration other alarm; refer to Fig 4-27:
Fig4-27 other alarm
Step2: select a hard disk in the pull down list box, when the disk capacity is lower than that value, there will appear some text information on the lower right
of the live image.
Step3: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button to exit current interface.
4.5.5 Alarm out
Alarm out includes three sub menus: alarm out, schedule and buzzer
Alarm out
Step1: enter into system configuration alarm out; refer to Fig 4-28:
Fig 4-28 system configuration-alarm out
Step2: in this interface, set relay alarm out name, select hold time which means the interval time between the two adjacent alarms.
Step3: user can setup all channels with same parameters, tick off “all”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button to exit current interface.
Schedule
Step1: enter into system configuration schedule;
Step2: the setup steps of alarm out schedule are familiar with schedule; user can refer to 4.4.1 Schedule for details.
Note: the default schedule of motion detection is full-selected, that is, the color of schedule setting interface is blue.
Buzzer
Step1: enter into system configuration buzzer;
Step2: tick off Buzzer, set buzzer alarm hold time
4.6 Network configuration
Network configuration includes two submenus: network and network stream.
4.6.1 Network
Step1: enter into system configuration network configuration network; refer to Fig4-29:
Fig 4-29 network configuration-network
Step2: HTTP port: the default value is 80. If the value changed, user needs to add the port number when typing IP address in IE address blank .i.e. set
HTTP port to 82, IP address: http://192.168.0.25, user needs to input that address: http://192.168.0.25:82 into IE browser.
Server port: communication port
Step3: Tick off the "Obtain an IP address automatically", the device will distribute IP address, subnet mask, and gateway IP and DNS server.
Step4: enable PPPoE, user can directly connect the DVR to internet via ADSL, then input the user name and password; click TEST button to test the
effectiveness of the relevant information.