LT Security LTD9056M6 - Manual (Page 7)

User Manual
5
Chapter 3: Installation
3.1 Install Hard Disk
NOTICE
: Don’t take out HDD when DVR is running.
(1) Take out the Hard Disk Drive tray carefully.
(2) Connect the power cord and data cable to hard disk carefully.
(3) Put the Hard Disk Drive tray back into the DVR and then lock the HDD tray.
3.2 Connecting Camera and Monitor
There are 4/9 camera inputs and 2/1 Monitor outputs with BNC connectors (Refer to 2.2 Rear
Panel).
3.3 VGA Output (optional)
T here is 1 CRT or LCD monitor output with VGA port.
3.4 Connecting Power Supply
Please only use the power adapter supplied with the DVR.
Chapter 4: Starting the DVR
4.1 Firmware Version
4.2 Detecting Installed Hard Drive
DVR will detect the installed hard drive and
display the hard drive information.
After connecting the power adapter and turning
on the power button, the system will boot-up and
display the version and released date of the DVR
firmware.
V1.9
V-EN-BG
2008.2.23
CHECKING HDD……
MASTER [WDC WD3200AAJB-00T]
SLAVE……