LT Security LTD1651M5 - Manual (Page 53)

2) CAMERA ID
After selecting CAMERA NO first for CAMERA ID changing, CAMERA ID can be
changed by imaginary keyboard of below figure. When ENTER button is pressed,
below figure will be appeared.
Movement in imaginary keyboard can be done by movement button such as LEFT ,
RIGHT or UP , DOWN button.
If ENTER button is pressed under “SPACE” selection, under-bar character will be
generated. If ENTER button is pressed under “BACK” selection, one character which
is added last will be eliminated. If ENTER button is pressed under “MODE” selection,
alphanumeric small character and large character will be exchanged. If ENTER button
is pressed on alphanumeric character, that character will be added in CAMERA ID.
In order to save modified CAMERA ID, “OK” should be selected before leaving
imaginary keyboard.
3) PTZ TYPE (Pan, Tilt and zooming protocol selection)
The high end camera(s) with panning, tilting and zooming function would be
connected with some of video inputs. The camera(s) has(have) its own control
protocol needed to control panning, tilting and zooming, according to PTZ camera
manufacturer.
In order to control the camera with PTZ function in local DVR as well as in network
viewer software remotely, proper PTZ TYPE should be selected in here. Your DVR
supports over ten PTZ cameras. According to customer requirements, PTZ control will
be added in it.
* NOTE: PTZ stands for pan, tilt and zooming.
* PTZ protocols: Panasonic/ Pelco-D/ PelcoP/ Techwin/ Niko/ DRX502A_DSC230s
/KRE_301_302/ GC_755_NP/ TOA_CC554/ RAS716LS and so on.
48