LumaSense Technologies LumaSMART Controller - Manual (Page 4)

[email protected] www.lumasenseinc.com
©2012 LumaSense Technologies. All rights reserved. LumaSense Technologies, Inc., reserves the right to change
the information in this publication at any time.
Americas and Australia
Sales & Service
Santa Clara, CA
Ph: +1 800 631 0176
Fax: +1 408 727 1677 Europe, Middle East, Africa
Sales & Service
Frankfurt, Germany
Ph: +49 69 97373 0
Fax: +49 69 97373 167 India
Sales & Support Center
Mumbai, India
Ph: +91 22 67419203
Fax: +91 22 67419201 China
Sales & Support Center
Shanghai, China
Ph: +86 133 1182 7766
Fax: +86 21 5877 2383
LumaSense Technologies Temperature and Gas Sensing Solutions
LumaSMART Quickstart-EN 514-0001-01 Rev. B 12/04/12
LumaSense Technologies Temperature and Gas Sensing Solutions
The “OR” logical function sets the system to alert when
any of the selected channels passes the Alarm set-point
temperature. The “AVG” logical function sets the system
to alert when the average temperature of the selected
channels passes the Alarm setpoint temperature.
Under Linked Channels, select the channels you would
like the logical function to apply to. Be sure to press the
Save button to apply your settings before leaving the
menu screen.
Alarm Setpoint - The temperature at which the relay
will change from the Normally De/Energized state to the
opposite state.
Restore Setpoint - The temperature at which the relay
will change from the present state back to its Normally
De/Energized state.
Analog Outputs
The Analog Outputs overview screen shows a list of the
channels and their current analog output configuration.
Press to the right of a channel to scale a channel
module’s temperature and current level. See section 5.2.1
for more details.
Channel Setup
The Channel Setup Overview screen allows you to
configure each channel’s name and status.
1) Press to change the channel name or enable or
disable a channel.
2) Press next to the channel name to bring up
a keyboard where you can enter an alphanumeric
channel name.
3) Press the circle above Enabled or Disabled to enable
or disable the channel. (Your selection will turn
green.)
4) Press before leaving the screen to save your
changes.
Display
The display screen allows you to configure channel scroll
speed, time until the backlight is dimmed, and the bright-
ness level of the screen.
Transformer Info
The Transformer info page displays the details about
the transformer. This information can be obtained from
the transformer manufacturer and entered into the
LumaSMART via the Setup menu.
The same text that appears under Transformer Name will
also appear at the top of the Main Menu screen.
Diagnostics
The Diagnostic menu provides tools to test probe signal
strength, communications, protocols and relay configura-
tion. It also provides a file viewer and the ability to erase
data logs.
Data
The Data screen allows you to export a range of data to a
USB thumbdrive.
To export data:
1) Select the date range of the data you would like to
retrieve by using the up/down arrows.
2) Insert your USB thumbdrive into the port located
below the touchscreen and press .
3) When export is complete, a message will appear on
the screen. Do not remove the thumbdrive until you
see the confirmation message.
Temperature data is stored once every minute. The latest
end date you can select is the current date (shown in the
top center of Main Menu screen).
For complete instruction, view the operational manual
located on the enclosed CD.