RIKON Power Tools 10-305 - Manual (Page 8)

b. Fasten the guide rail with two each star knob screw and washer
to the table. Use the hex socket head cap screw, washer and wing
nut for correcting the working table flatness. (See Fig. 2)
FIG. 1
FIG. 2
c. Lay the rip fence onto the guide rail. Adjust the rip fence parallel
to the saw blade. Tighten rip fence handle by pressing downward.
(See Fig. 3)
FIG. 3
d. Place the blade tension knob on to the blade tensioner located at
the top of the frame (See Fig. 4).
FIG. 4
e. To ensure sufficient upright stability of the machine it should be
bolted to floor, bench or worktable. For this purpose 6mm holes are
provided in the machine’s base. (See Fig. 5)
FIG. 5
f. The bandsaw has a 2-1/2” dust port included. (See Fig. 6)
It is recommended that when in use, the bandsaw is connected to a
suitable dust collector.
Dust port
FIG. 6
GETTING TO KNOW YOUR BANDSAW
8
Door locking knob
Blade guide
Lock switch
Guide rail
Blade tension knob
Upper table trunnion
Lower table trunnion
Dust port
Fence
Blade tracking knob
Guide post adjusting knob
Guide post locking knob
Motor
Blade Tension Knob