RIKON Power Tools 10-321 - Manual (Page 7)

7
J. Place the blade tension knob onto the blade tension assembly.
(See FIG. 8)
K. The band saw has a 2-1/2” dust port and 4” dust port included for
connection to standard width shop vacuum hoses. (See Fig. 9)
It is recommended that when in use, the band saw is connected to a
suitable dust collector.
I. Assemble the tool holder to the column of the band saw with two
pan head screws. Locate two pan head screws from the bag of
loose parts. Mount the tool holder to the column and install a pan
head screw in each hole, then tighten with Phillips screwdriver.
(See FIG. 7)
H. Attach the crank handle to the belt tension crank arm with the M6
Hex nut. (See FIG. 6)
FIG. 7
FIG. 8
FIG. 9
FIG. 6
Tool Holder
G. Use the hex socket head cap screw, washer, bushing and wing
nut for correcting the working table flatness. (See FIG. 5)
FIG. 5
Blade Tension Knob
E. Locate four hex bolts and four lock washers from the bag of loose
parts used to mount the table. Mount the table to the upper table
trunnion and install a bolt with washer in each hole, then tighten with
a 13mm wrench. (See FIG. 3)
Mounting Bolts
FIG. 3
Bushing &
Wing Nut
2-1/2” Dust
Port
4” Dust
Port
F. Next locate one Hex Bolt M8x45 and one Hex Nut M8. Install un-
der the table as shown. This assembly is used to level the table.
(See FIG. 4)
FIG. 4
Underside of
Table
Table Leveling
Bolt