RIKON Power Tools 10-346 - Manual (Page 6)

California Proposition 65 Warning
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction
activities contains chemicals known to the State of California to cause cancer and birth defects or
other reproductive harm.Your risk from exposure to these chemicals varies, depending on how
often you do this type of work. To reduce your exposure, work in a well-ventilated area and with
approved safety equipment, such as dust masks that are specially designed to filter out microscopic
particles.
For more detailed information about California Proposition 65 log onto rikontools.com.
1. Always allow the bandsaw blade to stop before removing scrap pieces from table.
2. Always keep hands and fingers away from the blade.
3. Never attempt to saw stock that does not have a flat surface, unless a suitable support is used.
4. Always hold material firmly and feed it into the blade at a moderate speed.
5. Always turn off the machine if the material is to be backed out of an uncompleted cut.
6. Adjust the upper guide about 1/8” to 1/4” above the material being cut.
7. Check for proper blade size and type for thickness and type of material being cut.
8. Make sure that the blade tension and blade tracking are properly adjusted.
9. Make “relief” cuts before cutting long curves.
10. Release blade tension when the saw will not be used for a long period of time.
SAVE THESE INSTRUCTIONS.
Refer to them often.
6
This owner’s manual is not a teaching aid. Use of this owner’s manual is intended to
show assembly, adjustments, and general use.
SPECIFIC SAFETY INSTRUCTIONS FOR BAND SAWS
NOTE: The specifications, photographs, drawings and information in this manual represent the current
model when the manual was prepared. Changes and improvements may be made at any time, with no
obligation on the part of Rikon Power Tools, Inc. to modify previously delivered units. Reasonable care
has been taken to ensure that the information in this manual is correct, to provide you with the guidelines
for the proper safety, assembly and operation of this machine.
SAFETY INSTRUCTIONS