RIKON Power Tools 25-200H - Manual (Page 13)

13
ADJUSTMENTS
Table Alignment continued from page 12
FIG. 18
FIG. 19
FIG. 20
NOTE: It may be easier to remove the fence assembly and
guard for this exercise.
3. Rotate the cutterhead so that the knife inserts do not
interfere with the measurements that will be taken.
4. With a long metal straight edge, place it length-wise
along the outfeed table so that it extends onto the infeed
table. The straight edge should lie level across BOTH
tables. If it does, the tables are true to each other, and the
machine guards can be re-set for use. FIG. 18.
If the straight edge does not lie flat across both tables, then
the tables must be adjusted. Tune the outfeed table, as the
infeed table was factory set to the cutterhead.
ADJUSTING THE OUTFEED TABLE
1. The outfeed table needs to be lifted up and back into
a verticle position. See page 19, step 1 & 2 for full details
on this process. The Dust Chute (#30) should be left in the
down, jointer-use position so adjustments can be made.
2. With the table up, the Mounting Base (#151) for the
out-feed table is exposed. The base has three Hex Bolts
(#154) and four Set Screws (#152) that fasten the table to
the cabinet. The set screws can be adjusted to slightly tilt
the table to align it with the infeed table. FIG. 19.
3. Slightly loosen the three hex bolts so that the set
screws can be adjusted. With small 1/8 or 1/4 turns of the
set screws, tilt the table as needed. A clockwise turn will
advance the set screw, a counter-clockwise turn will retract
them from the base casting.
- The pair of 2 set screws to the far left will raise the left
end of the table. FIG. 19, A & B.
- The pair of 2 set screws to the far right will raise the
forward edge of the table, nearest the cutterhead. C & D.
- The pair of screws furthest back in the base will tilt the
back of the table upward. B & C.
- The pair of 2 set screws at the front of the base will
lift up the front edge of the table. A & D.
- The table can also be tilted down, or up, towards a
specific corner should the situation arise. Three of the set
screws would be adjusted for this. Example: To tilt the far
left corner of the table up, set screws D, then A & C would
be turned. Screw B would be the 'pivot point'
4. The table can also be tilted forward or back with the two
Special Bolts (#142, FIG. 20, E & F). The combination of
the six bolts and screws (A-F) provide a great range of
table positioning to level it with the infeed table.
5. Once adjustments are made, the outfeed table should
be lowered and the flatness measurement taken again with
the straight edge.This may require a few attempts to get
the tables in alignment. Then the three hex bolts (#154)
can be tightened to lock the settings. The two Special Bolts
(E & F) should also be checked to make sure that they
both lie on the Cabinet, then tightened.
6. With the table lowered, make sure the safety Table Lock
(#146) will engage. This special bolt can be adjusted up or
down by its threaded end, then set with the nut . FIG 20, G.
7. Re-adjust, or install the fence and guard for use.
STRAIGHT
EDGE
E F
A
B
C
D
G