RIKON Power Tools 30-240 - Manual (Page 8)

8
Figure 6
Assembly
Head Assembly
1. Place the drill press head onto the column as
far as it will go (Figure 6). Align the drill press head
with the base of the drill press.
2. Tighten the drill press head to the column by
tightening the two set screws on the right side of
the head as shown (A-Figure 7).
3. Place the feed handle to the hub. Tightening
the set screw into the hub through the central
hole of feed handle (Figure 8).
Assistance is needed for this next
step.
NOTE:
Figure 7
A
Figure 8
Figure 5
6. Install the locking lever onto the table support
bracket and tighten the locking lever (Figure 5).
Continued from page 7