RIKON Power Tools 50-112 - Manual (Page 8)

8
Operation
Remounting Table for Vertical Sanding
1. Remove backstop lock bolt and remove work support.
2. Unscrew knob (34) and remove.
3. Pull table support (33) index pin out of mounting hole.
4. Loosen hex socket screw (75) and raise sanding bed to the desired sanding position.
5. Insert the table index pins into the auxiliary (upper) holes in the sanding bed.
6. Tighten hex socket screw (75). Make sure table is not touching sanding belt.
Leveling Table Assembly
1. Place a combination square on the table (35) so that it also touches the sanding pad (7).
See below. If the table is 90 degrees to the pad, the square is flush on the pad.
2. If the table is not 90 degrees to the with the pad, loosen the table lock knob (34) and tilt the
table until the square is flush with the pad
3. Retighten the knob to secure the table.
4. Attach the scale label to the ‘0’ degrees mark on the dust guard.
Auxiliary
Mounting
Holes
Table
Support
Knob (1)
Scale Label
Table Lock Knob (34)
Table (35)