RIKON Power Tools 60-100 - Manual (Page 6)

Fig. 01
Fig. 02
6
Assembly
Installing Casters to Base
Locate the four swivel casters, four M5 hex nuts,
four 5MM flat washers and four M5X8MM hex head
screws from the hardware pack.
1. Turn over the base plate and align the holes on
base plate with the holes from swivel caster.
2. Place the screws through the holes from the front
side of base plate. Install the flat washers and hex
nuts onto the screws and tihten (Fig. 01).
3. Repeat steps 1 and 2 for the remaining three
swivel caster assemblies.
Mounting Column to Base
Locate the column, four M8X10MM hex bolts and four
8MM washers.
1. Lay the column onto the base. Align the holes in
the column with the holes in the base.
2. Place a washer over a hex bolt and insert through
the column into the the threaded hole in the base
(A-Fig. 02).
3. Repeat steps 1 and 2 for the remaining three
hex bolts and tighten.
Mounting Collector Motor to Column
Locate the collector motor, four M6X10MM hex bolt
and four 6MM washers.
1. Place the collector motor into the column. Align
the holes in the column with the holes in the collector
motor.
2. Install a washer over a hex bolt and insert through
the column into the the threaded hole in the collector
motor (A-Fig. 03).
3. Repeat steps 1 and 2 for the remaining two
mounting positions and tighten.
Fig. 03
M5X8 Hex
Head Screw
5MM Washer
M5 Nut
A
A