RIKON Power Tools 70-500 - Manual (Page 9)

9
Fig.13
Warning:
Attaching Live Center on the Tailstock
Insert the live center, with a No. 2 Morse Taper
shank into the tailstock spindle. (Figure 16)
Installing The Faceplate to the
Headstock Spindle
Thread the faceplate clockwise on to the
headstock spindle. Next, engage the spindle lock
and stop the spindle from turning, and tighten
faceplate with supplied wrench. Reverse operation
to remove. (Figure 15)
For added convenience, a plastic washer is
offered to allow easy removal of the faceplate.
Install washer between headstock spindle face and
faceplate.
Disengage spindle lock before
turning the machine on.
Attaching Spur Center on the
Headstock
Insert the spur center, with a No. 2 Morse Taper
shank into the headstock spindle. (Figure 13)
Removing Spur Center on the
Headstock
Insert the knockout bar into the headstock spindle
from the handle end. Tap the end of the spur center
lightly until it releases from the spindle. (Figure 14)
Removing Live Center from the
Tailstock
Insert the knockout bar into the tailstock spindle
from the handle end. Tap the end of the live center
lightly until it releases from the spindle. (Figure 17)
Fig.14
Fig.15
Fig.16
Fig.17