RIKON Power Tools 10-340 - Manual (Page 8)

Figure 1
Figure 4 8
A
B
Figure 2
Figure 3
Assembly
The machine is supplied partly assembled. Prior to use,
the following items have to be assembled: working table,
rip fence and hand-wheels.
WARNING! To ensure sufficient upright stability and
safety of this Bandsaw, you need to bolt the Bandsaw to
the floor with M10 screws.(Fig 1)
(not supplied)
Assemble Working Table
Installing 90°stop: Thread screw (m8x20) and nut (M8-
1.25) to the bottom of the table. (Fig. 4A)
With the help of another person, lift the working table onto
the trunnion.
Mount the working table to the trunnion using the supplied
(4) hex bolts, (4) lock washers and (4) washers (A--Fig.2).
Installing Table Leveling Screw: Insert hex socket screw
and washer through top of table. Place bushing and wing
nut from under the table and tighten. (B--Fig. 2)
Assemble Rip Fence
Install the rear fence rail to the table with (2) M6-1.0 x 20
hex bolts and (2) flat washers M6 (Fig. 3).
Install the front fence rail to the table with (4) thumbscrews
and (4) flat washers M8 (Fig. 3).
Make sure the end cap is locked into the rear fence rail.
Then set the fence on the front and rear rails.
Assemble Hand-Wheels
Attach the large crank handle (Fig. 4) to the rack and
pinion on the upper part of the bandsaw, using the 5mm
“L” wrench provided.
Attach the small crank handle (Fig. 4) to the belt and
speed control rod on the lower right side of the bandsaw,
using the 5mm “L” wrench provided.
Place the (4) “L” wrenches (3mm, 4mm, 5mm and 6mm)
in the tool holder on the rear column support.