RIKON Power Tools 20-100 - Manual (Page 9)

9
Figure 6
Figure 7
Figure 8
Installing Belt Guard
1. Place the belt guard (A-Fig. 6) over the belt
opening in the stand.
2. Line up the holes in the stand with the holes in
the guard.
3. Attach the guard to the stand using two 1/4-
20x1/2" pan head screws and two 1/4" lock
washers. (B-Fig. 6) Make sure belt is clear of
the guard.
Install Fence Bed Casting
1. Use two 3/8" x 1-1/2" hex socket bolts and
washers (A-Fig. 7) to attach the fence bed
casting (B-Fig. 7) to the outfeed table bed
using 13mm socket wrench.
2. Align top of the fence base casting flush with
the table surface and tighten.
Installing Fence to Bed
1. Remove the lock handle (A- Fig. 8), flat
washer, and lock nut from the carton.
2. Place the fence assembly onto the table. Be
sure key stock (B- Fig. 8) on the bed lines up
with channel in the fence casting.
3. Place the flat washer and insert the lock
handle through the fence casting and the table
casting.
4. Thread the special nut onto the lock handle.
Make sure the tab on the nut faces up and
engages the slot in the table casting. (C-Fig.
8)
A
B
Assembly
A
B
A
B
C