Seca 285 - Manual (Page 115)

The seca 360° wireless network • 115
English
NOTE
As soon as you have integrated a wireless
printer in the wireless group, you must then
select a print option (menu\rf\APrt) and set the
time (menu\rf\time).
12. Repeat step 11. for all devices you wish to integrate
in this wireless group.
ATTENTION!
Loss of the wireless link with the head slide
If the head slide is switched off while the
wireless group is being set up, its wireless link
with the multifunctional display is lost.
− Switch on the head slide together with all
devices you want to integrate in the wireless
group.
13. Press the Enter key to end the search.
14. Press an arrow key to see which devices have been
detected (here: Mo 3 for a wireless printer).
Once you have integrated several devices in the
wireless group, press the arrow key several times to
ensure that all devices have been detected by the
scales.
15. Press the Enter key to leave the menu or wait until
you leave the menu automatically.
Activate automatic
transmission (ASend)
You can configure the device so that the measured
results are automatically transmitted to all receivers that
are ready to receive and logged into the same wireless
group (e.g.: wireless printer, PC with USB wireless
module).
NOTE
If you are using a wireless printer, ensure that
the print option is not switched to "off" (see
“Select print option (APrt)” on page 116).
1. Switch the device on.
2. Select the "ASend" menu item from the "rf"
submenu and confirm your selection.
3. Select "on" and confirm your selection.
You will leave the menu automatically.