Seca 285 - Manual (Page 121)

Maintenance/Recalibration • 121
English
10.2 Change the batteries of the head slide
You require 4 Mignon batteries, type AA, 1.5 volt. To
connect the power supply for the head slide, proceed
as follows:
1. Remove the cover of the battery compartment.
2. Remove the battery holder from the battery
compartment.
3. Remove the spent batteries from the battery holder.
4. Insert the new batteries in the battery holder.
NOTE
Observe correct polarity of batteries (markings
on battery holder).
5. Insert the battery holder into the battery
compartment.
ATTENTION!
Damage to device and malfunction due to
clamped or pinched cable
− Lay the battery cable before closing the
battery compartment so that it cannot get
clamped between the cover and the battery
compartment.
6. Slide the cover onto the battery compartment until
it audibly latches into position.
11. MAINTENANCE/RECALIBRATION
11.1 Information about maintenance and recalibration
We recommend having the device serviced before
recalibrating the scales.
ATTENTION!
Incorrect measurements due to improper
servicing
− Make sure that maintenance and repair are
only carried out by an authorised service
partner.
− You can find your local service partner at
www.seca.com or send an e-mail to
[email protected].