Seca 285 - Manual (Page 82)

82 •
Installing the push-in
scale
ATTENTION!
Incorrect measurements due to installation
errors
If the push-in scale is installed incorrectly the
head slide cannot determine any usable
readings.
− Align the push-in scale so that the printing
remains visible when the scale is pushed into
the groove.
− Align the push-in scale so that the area which
shows the product number forms the bottom
end.
− Ensure that the push-in scale latches into
position under the end cap.
• Push the push-on scale into the groove in the side
of the column elements until the scale latches into
position under the end cap.
5.3 Set up device
ATTENTION!
Incorrect measurement with force shunt
Correct measurements cannot be taken if the
patient's weight is not fully positioned on the
weighing area.
− Set up the device so that it only makes
contact with the ground via the foot screws.
− Set up the device so that the weighing area
does not touch any other objects.
− While you are weighing, ensure that the
patient does not touch the upright of the
device.
1. Place the device on a flat, stable surface.