Seed Hawk LOUP III & VIPER PRO 2013 - Hydraulic Drive Calibration Guide - Manual (Page 13)

Seed Hawk
®
Manual Calibration Guide
12
Step 7: Enter the total
weight of product caught
minus the weight of the
empty calibration bucket.
Select "OK" when finished.
Step 8: Calibration for this meter is now complete, repeat steps
to calibrate remaining meters.
ATTENTION:
DO NOT include the weight of the calibration bucket in the
metered weight value.
The monitor MUST be powered down properly by pressing
and holding the power button until the monitor powers
down. Failure to do so will result in lost data.