Seed Hawk AIRCART 2012 - Manual (Page 53)

Seed Hawk
®
Manual Aircart Page 48
7.3.1.5.3 FAN SETTINGS
Pulses per rev: This is the number of pulses
produced by the fan sensor in one revolution.
The pulse setting is equal to the number of
targets presented to the fan sensor in one
revolution.
Low RPM Alarm: The Low Alarm Limit is set by
the user for low rpm notification. Default is 1500
RPM
High RPM Alarm: The High Alarm Limit is set by the user for high rpm
notification. Default is 5500 RPM.
NOTE
7.3.1.5.4 BIN SETTINGS
: Fan RPM above the High Alarm Point or Below the Low Alarm Point
will cause an alarm condition that cannot be acknowledged. The
problem must be fixed.
The Bin Settings Menu shows the Alarm status. User
may select to disable or enable the bin sensor alarm.
7.3.1.5.5 IGNORE / REVIVE A SENSOR
A User may select to ignore a sensor. Ignoring a sensor does not uninstall the
sensor from the system. It simply puts the sensor to sleep. Highlight the sensor
you would like to ignore. On the Soft Key Menu, press Ignore. When you are
ready to use the sensor again, highlight the sensor once again and choose
Revive on the Soft Key Menu.