SHARKOON 5.25 BayExtension - Manual

Alternatively, one 3.5" HDD and two 2.5" HDDs, or SSDs, can be mounted to the BayExtension simultaneously,
at which the 3.5" HDD is mounted decoupled:
Installation:
1. Place one 3.5" HDD into the mounting bay on the top side of the BayExtension mounting frame.
2. Screw the HDD to the BayExtension mounting frame from underneath through the decouplers using the
included coarse thread screws.
3. Place two 2.5" HDDs/SSDs into the mounting bays on the lower side of the BayExtension mounting frame.
4. Screw both HDDs/SSDs to the BayExtension mounting frame from both sides using the included fine
thread screws.
The BayExtension mounting frame can be mounted to standard 5.25" bays of PC cases and is attached with
four fine thread screws.
Installation:
1. Open the PC case.
2. Slide the BayExtension mounting frame with pre-installed HDDs into a 5.25" mounting bay of the case.
Refer to the installation guidelines included with the case.
3. Screw the BayExtension mounting frame to the case using the included fine thread screws. Refer to the
installation guidelines included with the case.
Legal disclaimer:
As a continuing policy of product improvement at SHARKOON, the design and specifications are subject to
change without prior notice. National product specifications may vary.
All rights reserved especially (also in extracts) for translation, reprinting, reproduction by copying or other
technical means. Infringements will lead to compensation.
All rights reserved especially in case of assignation of patent or utility patent.
Means of delivery and technical modifications reserved.
© SHARKOON Technologies 2012
1
2
3
2
5.25" BAyexTeNSION
www.sharkoon.com
1
View from above:
A – Mounting bay for one 3.5" HDD
B – Decoupled attachment for one 3.5" HDD
C – Mounting frame attachment
a – Mounting bays for two 2.5" HDDs/SSDs
b – Screw openings for two 2.5" HDDs/SSDs
c – Mounting frame attachment
View from underneath:
A – Overlapping mounting bays for two 2.5" HDDs/SSDs
B – Screw openings for the two 2.5" HDDs/SSDs
The BayExtension mounting frame allows for the simultaneous installation of up to four 2.5" HDDs or SSDs:
Note:
Related to their design mechanical 2.5" HDDs shall not be
installed headfirst!
Installation:
1. Place two 2.5" HDDs/SSDs into the mounting bays on the top side of the BayExtension mounting frame.
2. Screw both HDDs/SSDs to the BayExtension mounting frame from underneath using the included fine
thread screws.
3. Place two 2.5" HDDs/SSDs into the mounting bays on the lower side of the BayExtension mounting frame.
4. Screw both HDDs/SSDs to the BayExtension mounting frame from both sides using the included fine
thread screws.
5.25" BAyexTeNSION
Manual
c
c
c
c
C
C
C
C
B
B
B
B
B
B
B
B
A
A
a
a
b
b b
b
b
b
b
b
1
2
3
4