SHARKOON X-Tatic Digital - Manual (Page 12)

X-TATIC DIGITAL
6.2 Restore the factory default / reset
To restore the factory settings press and hold the buttons “Vol -” and “Vol +”
(fig. 3 / A) simultaneously while the SCU is switched off then press the power button
(fig.3 / B). The LED display (fig. 4) will flash 3 times to confirm the successful reset.
fig. 3
fig. 4
7. Using the X-Tatic Digital with a PC (optical output)
1. Connect the optical cable (remove protective caps!) to the optical audio output of your
PC’s soundcard and the SCU’s optical audio input.
2. Connect the X-Tatic to the SCU by plugging the headset cable’s 9-pin connector to
the SCU’s 9-pin plug.
3. Connect the USB microphone cable to the respective plugs of the SCU and your PC.
4. Connect the power supply delivered with the X-Tatic to a wall outlet, the adapter‘s
angled power plug to the SCU‘s ISO power jack and the straight power plug to the
respective headset cable’s power connector.
Note:
In case you are using the version with two separate power adapters, proceed as
follows:
4. a) Connect one of the included power supplies to a wall outlet and the angled
power plug to the SCU’s ISO power connector.
4. b) Connect the second power supply delivered with the X-Tatic to a wall outlet
and the straight power plug to the headset cable’s ISO power connector.
5. Alternatively connect the single 3.5 mm jacks of any 5.1 headset to the SCU’s
according analog plugs (instead of the USB microphone cable the microphone is directly
connected to the soundcard). For a better distinction the connectors are color coded.
6. Switch on the SCU and boot up your PC.
Note:
If you are facing any failures using the microphone function via USB we recommend
to check your operating system’s audio settings and to define the soundcard as output
device and the USB microphone as input device.
A
B