SHARKOON Scorpio 2000 - Manual (Page 14)

scorpio 1000/2000
8. Installing an add-on card
1. Remove the slot bezel from its attachment.
2. Insert the add-on card into the mainboard’s respective slot and
screw it to the case (fig. 19).
(Screws for drive/mainboard mounting)
fig. 19
9. The pre-installed fans
1. The pre-installed case fans provide a 3-pin mainboard plug each.
2. Connect the plugs to either the respective mainboard or fan
connector of the circuit board (fig. 20).
fig. 20
10. Installing additional fans /
optimized airflow
10.1 Side panel
1. Place the fan (1x 200 mm or 2x 120 mm) against the respective
fan bracket from the inside. Screw the fan to the side panel from
the outside.
2. Connect the fan’s power connector to the mainboard or the PSU.