ShelterLogic 62696 13 x 20 x 12 Garage-in-a-Box SUV/Truck - Manual (Page 8)

05_62693_62696_0F Page 8
7. Door AnD BAcK PAnel InSTAllATIon
A. Hold end panel at the top center with white inner surface facing inside of the shelter. Wrap the edges of the
fabric panel around the end rib.
B. Disconnect top rail (the horizontal pipes that run from front to back along the top) from the end rib. Pull the
webbing (the black strap) below the cross rail. Reattach the top cross rail to the end rib. Repeat Step B for
side rails (the horizontal pipes that run from front to back along the sides of the unit, near the bend in the
frame where the legs meet the roof).
C. At the bottom, where the webbing exits the pocket on each side of end panel, pull webbing to remove the
slack. Be careful not to pull the webbing through the other side of the webbing pocket.
D. Insert the “S”- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself.
Position the end panel so that it is centered on the building before fully tightening the end panel.
E. Tighten ratchets, alternating from one side to the other, until the end panel is centered and tight.
Thread Webbing Into Ratchet Webbing and Ratchets Securing End Panel
noTe: Keep Zippers closed when tightening end panels.
IMPorTAnT!
DO NOT INSERT ANY PIPES
INTO THESE POCKETS.
WrAP enD PAnel eDGeS oVer AnD AroUnD
PIPe ToWArDS InSIDe oF FrAMe.