Assembly instructions model # sp-65 – SnowEx SP-65 User Manual
Page 8
Advertising
© TrynEx International 2013 (REV B) F50753
8
Assembly Instructions
Model # SP-65
STEP 4
Install the other Wheel. Slide the 1.5” Cotter Pin through the Axle,
outside the Wheel.
STEP 6
Install Hopper. Put Bolts with Washers through all four holes in Hopper
and Frame. Thread on the Nuts.
STEP 5
Install Frame Stand. Attach to the Hopper Supports.
STEP 7
Put Agitator Pin through Spinner Shaft inside hopper.
STEP 8
Bolt Cable to both handles. It should be positioned so the cable points
toward the base of the handle and will be to the operator’s left. Hand-
tighten only.
Advertising