SoleusAir SG-PAC-08E4 - Manual (Page 8)

CONTROL PANEL, DISPLAY, & OPERATING INSTRUCTIONS
CONTROL PANEL & LED DISPLAY
CONTROL PANEL OPERATING INSTRUCTIONS
1) Power On and Off - Press the POWER button once to manually turn the unit on. Press the POWER
button once more to turn the unit off.
2) Mode Selection - Press the MODE Button repeatedly to cycle between the different modes: Cool, Dry
and Fan only mode. Each press of the MODE button will light up a different icon on the control panel.
The exhaust hose and window kit must be installed when the unit is in cool or dry mode.
When using the unit as a fan, it is not necessary to keep the exhaust hose and window kit connected to the
unit.
3)
Temperature - Select the desired temperature by pressing either “ - ” or “ + ” key when using the unit in
cooling mode. The digital thermostat will display the set temperature.
4) Louver Direction - This unit has 4-Way directional louvers. Use the louver guides to direct air where
cooling or fanning is needed most.
5) Bucket Full - When the unit cannot evaporate the collected moisture fast enough. The excess water will
collect in a backup water tank located inside the unit. The bucket full icon will light up if this occurs.
REMOTE RECEIVER
MODE BUTTON TEMP SELECT BUTTON POWER BUTTON
BUCKET FULL LIGHT
COOL MODE LIGHT DRY MODE LIGHT
FAN MODE LIGHT LED DISPLAY
8