SoleusAir HM10-15E-32 - Manual (Page 7)

7
OPERATING INSTRUCTIONS
CONTROL PANEL
1. Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate
heater in upright position with base brackets attached.
2. Turn the heater on by pressing the ON/OFF button on the control panel.
3. Select a heat setting:
On the control panel, press the MODE button to toggle between the two heat settings; LOW (1000W) or
HIGH (1500W) . Adjust the thermostat by pressing the TEMPERATURE SELECT buttons (▲ or ▼) on
the control panel. The digital display will show the selected temperature.
4. Once you have chosen the desired temperature, the heater will remain on until the room temperature
increases to the temperature on the digital display. The heater will cycle on and off to maintain the desired
room temperature.
5. The indication lights on the control panel communicate how the heater is operating. When HIGH and
LOW modes are selected, the corresponding lights will turn on accordingly.
6. Unplug the heater when not in use.
Temperature Select Buttons
Mode Select Button
ON/OFF Power Button
Temperature Display
Indication Lights