SoleusAir SG-PAC-10E2 - Manual (Page 10)

CONTROL PANEL & DISPLAY
When pressing key is valid, buzzer makes a sound, indicated light indicates relevant state, system will last for
2 seconds.
OPERATING INSTRUCTIONS
l.
3.MODE Button
4. Fan Speed
When the unit is running in Cool or Fan mode, press the Fan speed Button to select the fan speed in High,
Middle, Low , Auto. In cool mode, it can decrease the temperature of the room, and make people very
comfortable.
ON/OFF Button
2. "+","-" Button
In COOL mode, press "-" once, the set temperature will decrease 1 , press "+" once, the set temperature will C( F)
Receiver window
LED window
DRY mode light
Temperature selection button COOL mode light
MODE button FAN mode light FAN Speed light ON/OFF button
Fan speed button
Button
CONTROL PANEL DISPLAY & OPERATING INSTRUCTIONS
6. Louver Direction
This unit has 4-Way directional louvers.
Use the louver guides to direct air where
cooling or fanning is needed most.Hold the
louver and adjust the air flow direction,
as shown in the right diagram.
5.Water Full
When COOL or DRY is running, condensate will drain to water tank. When water tank is filled, buzzer will sound 8
times, LED screen show error code ‘H8’.
In this case, reference page 8 to drain out water intank.
Press the button once to manually turn the unit on. Press once more to turn the unit off.
Press MODE Button repeatedly to cycle between the modes:Cooling,Dry,and Fan only mode. Each press of
the MODE button will light up a different lights on the control panel. The exhause hose and window kit must
be installed when the unit is in Cool or Dry mode. When using the unit as a fan, it is unnecessary to keep the
exhaust hose and window kit connected to the unit.
Hold this hand grip to adjust the
direction of Horizontal Louvers
Hold this hand grip to adjust the
direction of Vertical Louvers
increase 1C ( F). The set temperature range from 16 C to 30 C(61 F to 86 F).
1
0