Spectra Precision ProMark 120/220 Handheld Platform - Manual (Page 35)

English
29
GNSS Toolbox
GNSS Toolbox is used to control and monitor important
functions in your receiver. These are listed and detailed
below.
• Options: Lists the installed firmware options and allows
you to install new options.
• GNSS Settings: Constellations and frequencies used in the
receiver.
• Differential Mode: Used to make the necessary settings to
allow the receiver to process corrections it acquires from
the specified communication means (radio, network,
modem or other).
• NMEA Output: Used to set the output of standard NMEA
messages on a serial port (RS232 or Bluetooth) or to a
file.
• GNSS Status: Views GNSS reception monitoring screens.
• Reset: Resets the receiver.
• Troubleshooting: Allows data to be recorded for debugging
purposes. Proprietary commands can also be sent from
this module.
• About: Views versions of installed software and firmware.
• Turn off GNSS: Allows you to turn off the GNSS section of
the receiver when GNSS reception is temporarily
unnecessary for the tasks you are currently running with
your receiver. Turning off GNSS reception will significantly
save the battery operating time.
Options • Open the GNSS Toolbox and tap on Options. This opens a
new window listing the currently installed firmware
options.
• Use the Install button if you want to install new firmware
options in the receiver. The Option field lists all the
firmware options that can still be installed in your
receiver.
To install a new option:
– Select this option from the Option field
– Enter the activation key in the Key field. This key was
provided by Spectra Precision after you purchased this
option.
– Tap OK to complete the installation of the option. This
option will appear afterwards in the list of installed
options.