Star Lights Brilliant Light 3010 12 Volt Jack - Manual (Page 3)

- 3 -
INSTALLING The Brilliant Light 3000 ™ series
IMPORTANT-DISCONNECT THE BATTERY
STEP 1: Remove the old ceiling lighting fixture and clean area of all old sealer, dirt, etc.
STEP 2: Attach the WHITE wire marked positive (+) on the Brilliant Light 3000
™ series fixture to the
positive wire (+) coming out of the ceiling opening inside the RV.
STEP 3: Attach the WHITE wire marked negative (-) on the Brilliant Light 3000 ™ series fixture to the
negative wire (1) coming out of the ceiling opening inside the unit.
STEP 4: Re-use the original screws from your old fixture, to attach the Brilliant Light 3000 ™ series fixture
to the interior of the unit.
STEP 5: Replace the Brilliant Light 3000 ™ series Lens.
MODULE UPGRADE DIRECTIONS for the Brilliant Light 3000 ™ series
The following Modules can be added to the Brilliant Light 3000 ™ series.
 BL-3004 Dimmer Dial Module
 BL-3005 Night Light Module
 BL-3006 Motion Detection Module
 BL-3007 PCB Control Board Module
 BL-3008 Day/Night Sensor Module
STEP 1: Locate the PCB cover pry points as shown below.
STEP 2: the plug and replace with the appropriate upgrade module.