Star Water Systems 473707 - Manual

QUICK REFERENCE GUIDE.
SEE INSTRUCTION MANUAL FOR
COMPLETE DETAILS.
GARDEN HOSE UTILITY PUMP
MODELS HPP360, HPP12V, 473707
Outlet Inlet
Outlet
Inlet
Outlet Hose
Water Source
Outlet Inlet
3 ft. Max.
Vertical
1 2
3 4 5
Pump should be located so that the water source is within reach
of supplied 6 ft. inlet hose.
Install inlet hose on the inlet side of pump.
Attach 5/8 in. outlet hose (not included) on the outlet side of pump.
NOTE: Outlet hose should be as short as possible and no longer
than 25 ft.
To prime pump, fill the pump cavity through inlet to wet impeller.
Connect supplied 6 ft. inlet hose and submerge below surface of
water. Turn on pump.
Models HPP360 and
473707: Plug the cord
into a 3-wire, 115 volt, 60
Hz grounded A/C outlet
protected by a ground-
fault circuit interruptor.
This unit is shipped with a Puddle Vac accessory for removing
water from flat surfaces.
CAUTION: Before water is completely gone, unplug the pump.
DO NOT RUN PUMP DRY!
023912 B
PRIMING INSTRUCTIONS:
IMPORTANT: Pump MUST be primed before it is turned on.
OPERATING
INSTRUCTIONS:
IMPORTANT: For best
results, DO NOT COIL
OR kINk THE HOSES.
PUMP LOCATION: ATTACHING HOSES:
TURNING PUMP ON:
Model HPP12V:
Attach red
battery clip to
positive terminal
and black battery
clip to negative
terminal of a fully
charged battery.
Outlet Hose
Water
Source
Discharge
Water
Battery
Negative
Terminal
Black Battery
Clip
Positive
Terminal
Red
Battery
Clip
Description Quantity
Pump 115V or 12V 1
Inlet Hose 1
Puddle Vac 1
MODEL #HPP12V MODEL #HPP360 / 473707