Tele Vue Mount Handle - Manual

Parts List: Parts List: Parts List: Parts List: Parts List:
1) Foam covered Mount Handle
2) Handle Attachment Block
3) Parts Bag including:
2 #10-32 button head screws
1 Allen (Hex) Key
Introduction Introduction Introduction Introduction Introduction
Thank you for purchasing the Mount Handle for the Tele Vue Tele-
Pod and Panoramic Mount. Adding the handle to the bottom of the
cradle will give you more control over the movement in both axes.
Installation: Installation: Installation: Installation: Installation:
If you have a Tele-Pod or Panoramic Mount head that has a cradle base
pre-drilled to accept the mount handle assembly:
1) Hold the Handle Attachment Block under the left or right side
(whichever you prefer) of the cradle base and line up with holes.
2) Thread in the button head screws and tighten with the supplied Allen
Key.
If your Tele-Pod or Panoramic Mount head is NOT pre-drilled for the
Mount Handle:
1) Using the supplied template as a guide, set your head up on a drill
press and drill 3/16" diameter clearence holes in either or both sides
of the cradle base.
2) Hold the Handle Attachment Block under the left or right side
(whichever you prefer) of the cradle base and line up with holes.
3) Thread in the button head screws and tighten with the supplied Allen
Key.
Removal: Removal: Removal: Removal: Removal:
For storage, you may unscrew the foam covered handle from the
adapter block.
MOUNT HANDLE INSTRUCTIONS
32 Elkay Dr., Chester, New York 10918 (845) 469-4551 www.televue.com
Tele Vue
V i s i o n a r y
Parts Bag
Contents
Mount
Handle
Attachment
Block
Mount
Handle
Foam
Covered
Grip
Mount Handle
attached to
Tele-Pod
Button
Head
screws
Cradle
Base
Mount
Handle
Attachment
Block