Tele Vue Eyepiece Caddy Set - Manual (Page 3)

BOTTOM SURF
ACE
BACK SURF
ACE
1.50
Drill 17/64 dia. (2 pl) If arms not pre-drilled
.50
1.25
EYEPIECE CADDY MOUNTING HOLE POSITIONS IN YOKE ARMS OF: PANORAMIC/GIBRALTAR/
UPSWING/TELEPOD HEADS
NOTE: Tele Vue strongly recommends using a drill press, not a hand drill for making these holes.
1) Transfer the measurements from the drawing to your Yoke arm.
Or, cut out the template and tape it to the outside of the Yoke arm, with the bottom and back surfaces
aligned with the corresponding surfaces of your yoke arms.
2) Center punch the holes to be drilled.
3) Secure the mount head so it won't move while drilling.
4) Drill the holes with a 17/64 diameter drill.
RIGHT YOKE ARM TEMPLATE
INSTTEC -598
ARM
EYEPIECE CADDY
32 Elkay Dr., Chester, New York 10918 (845) 469-4551 televue.com
Tele Vue
®
V i s i o n a r y