Handle/locking system installation instructions – Tennsco 1480 User Manual

Page 3

Advertising
background image

2.

Turn the handle to

the open position,

and place the

locking cam (Ref.

No. 13) over the

square shank of

the door handle.

The latch must be

facing downward

as shown.

8.

Place the bottom (Ref. No. 7) in the bottom

lances of

the shelf adjustment strips. The

flange with

two holes

should

face the

front, and

it should

hang over

the sill.

Bolt to the

sill with two

two bolts and nuts.

9.

Attach the top (Ref. No. 8) by sliding it

under the header and sides, with the

flange hanging over the back.

Secure with 14 bolts

and nuts (three

along each

side, four

in the back,

and four

along the

front).

11.

Attach the left door

(Ref. No. 9) to the unit by

placing the door on the hinges,

aligning the holes, and using

a hammer to tap the hinge

pins (Ref. No. 16) into place

with the side of a screwdriver.

10.

Set the unit upright and insert

the remaining shelves at

your desired levels.

Insert shelf into

bottom lances.

Two

hole

s m

ust

be in

fro

nt.

12.

Attach the right door

(Ref. No. 10) to the unit

in the same way you

attached the left door.

1.

Place the locking

handle (Ref. No. 12)

on the right hand

door and fasten with

two slotted bolts with

lockwashers.

Handle/Locking System Installation Instructions

4.

Place the locking cam

retainer (Ref. No. 14)

over the square

shank of the door

handle. Tap on the

edges of the cam

retainer with a

hammer until retainer

sits firmly against the

locking cam.

3.

With the handle still in the open

position, hook the locking bars (Ref.

No. 11) to the locking cam (see "A" at

left). Then, hold the lock bars in

position while sliding the nylon lock

bar guide inserts (Ref. No. 15) over

the lock bar ends and through

the door slots (see "B" at left).

A

B

B

Advertising