Tennsco 1471 - Manual (Page 2)

ASSEMBLY OF 1471 CABINETS
1. All reference numbers refer to the illustration on
the back cover. This is to help you to identify the
various parts as they are mentioned.
3. Place the cabinet back (Ref. No. 1)
on a protected surface to
prevent scratching the
paint. The flange
on the bottom of
the back should be
facing upward.
5. Attach the right side (Ref. No. 3) to the back in
the same manner as you
did in step 4.
Make sure
that the
lances
on the
right side
are pointed in
the same direction
as those on the back and
the left side.
8. Locate the two keyhole-shaped slots on the top
front of each end-panel. Attach the header (Ref.
No. 5) in the same way you attached
the sill, by inserting the previously
attached loose bolt heads
into the large end
of the key-
hole
slots
(Inset D).
Position
by sliding
the bolts
securely into the
smaller end of the slots. Refer to Inset C
(in step 6 above) for improper and
proper seating of the boltheads. Tighten
the four nuts securely.
Flange
faces
upward
7. Insert the shelf (Ref. No. 4) into the top
position on the shelf adjustment strips.
Do this by inserting the shelf edges
into the lances on all four strips.
Be sure that the channeled edge
of the shelf is toward the
cabinet front. If a
lance is too
tight, it
may be
helpful to
use a
screwdriver
to SLIGHTLY
pry it open.
Two bolts
and nuts on
each side
Inset D
2. Prepare the header (Ref. No. 5) for
installation by inserting a bolt into
the two outside holes on
each end, as
shown in Inset A.
The center hole
should remain empty.
Loosely attach nuts to each bolt,
leaving enough slack so that
the bolt heads may later be insert-
ed into a slot. Prepare the sill (Ref.
No. 6) in the same way.
Sill
Hea
der
Inset A
4. Attach the left side (Ref. No. 2) to the back by
placing flange (A) around the back and
bolting the pieces
together with
seven bolts
and
nuts
(Ref.
Nos.
18 &19).
Be sure that
the lances on
all shelf adjustment
strips (B) point in the same direction.
6. Locate the two keyhole-shaped
slots on the front of
each end-panel
bottom. Attach
the sill (Ref.
No. 6) by
inserting the
loose bolt heads
(which you attached
to the sill in step 2) into the large end
of the keyhole slots (Inset B). Position
by sliding the bolts securely into the
smaller end of the slots. Inset C at right
shows improper and proper seating of
boltheads. Tighten the four nuts securely.
Tools Needed: A free 11 /
32
" nut driver is provided with each Tennsco cabinet (Ref. No. 19). In addition,
you will need a flathead screwdriver. A hammer is required to install the hinge pin and lock bar.
Two people recommended for assembly. Approximate assembly time: 15 to 25 minutes.
Inset B
Inset C
Improperly
seated
Properly
seated
A Flange goes
under back
B
All lances point UP
on both back
and side.