Handle/locking system installation instructions – Tennsco 2470 User Manual

Page 3

Advertising
background image

2.

Turn the handle to the

open position, and place

the locking cam (Ref. No. 10) over the

square shank of the door handle. The

latch must be facing

downward as shown.

9.

Place the bottom (Ref. No. 7) in the lowest notch

of the shelf adjusting strips on the sides and

back. Make sure the flange with two holes faces

the front, and that

it is over the flange of

the frame sill. If

necessary,

you may

push out on

the side walls to

enable the bottom to

more easily slide into position. Attach the shelf

securely by bolting the bottom to the frame sill

with two bolts and nuts.

10.

Set the unit upright

and insert the

remaining shelves at

your desired levels.

The shelf you inserted

earlier may also be

moved to a different

level if desired.

1.

Place the locking handle (Ref. No. 9) on the

right hand door and

fasten with two #8-32 x

1/4 slotted bolts and

lockwashers (Ref. No. 14).

Handle/Locking System Installation Instructions

4.

Place the locking

cam retainer (Ref. No. 12)

over the square shank of

the door handle. Tap on

the edges of the cam

retainer with a hammer

until retainer sits firmly

against the locking cam.

3.

With the handle

still in the open

position, hook the locking bars (Ref.

No. 8) to the locking cam (see "A" at

left). Then, hold the lock bars in

position while sliding the nylon lock

bar guide inserts (Ref. No. 11) over

the lock bar ends

and through the

door slots (see "B"

at left).

B

B

8.

With the door & frame assembly in place, attach it

securely to the

unit by opening each door,

one at a time, and securing

the frame assembly using

2 bolts and 20 nuts

(Ref. Nos. 16

and 17). This

will require

attaching

nuts to the

nine pre-welded

bolts along each

side, plus two bolts and

nuts along the top. The bottom

will attach to the frame in Step 9.

11.

The cabinet must be

level in order for the

doors to close

properly. Levelers

may be adjusted by

placing a screwdriver

through the hole in

each end of the sill

and adjusting the

leveling screw.

Leveler

Access

Holes

A

5.

Attach the "dummy"

handle (Ref. No. 13) to

the left door using two

#8-32 x 1/4 slotted

bolts and lockwashers

(Ref. No. 14).

Two

holes

must

be in front.

Insert

shelf

into

bottom

lances.

Advertising
This manual is related to the following products: