Avital 4113 - Manual (Page 12)

12 © 2009 Directed Electronics. All rights reserved.
While the vehicle is running during remote start operation, the system
will monitor the vehicle and will automatically shut down the engine if
the system receives any of the following shut-down inputs:
• Brake pedal is pressed.
• Hood is opened.
• Shutdown toggle switch is put into the ON position.
• Pre-programmed run time has elapsed.
• Remote control button is pressed and held for 3 seconds.
➢
Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release the remote control
button for 1 second.
2. Turn the ignition key to the OFF position. (The engine will stay
running.)
3. The engine will run until the pre-programmed time elapses or a
shut-down input is received. (See the previous Remote Start section
for a complete list of shut-down inputs.)
Note:
This feature will not work if the brake pedal is being pressed.