Tennsco Add-A-Stack - Manual (Page 4)

9
END VIEW OF UNITS AFTER THEY ARE COMPLETED
STEP 6) Attach End Plate Angle (#14) to track assembly using one bolt and nut as shown.
STEP 7) Place Spacer in front of stationary unit, locate track assembly(#2) in front of unit and flush with end of unit. At
both ends of the floor assembly, attach one end of the Track End Plate (#13) to the End Plate Angle (#14) using two (2)
machine screws (#15). Then attach this assembly to the end of the shelving. This will insure that this floor assembly
does not move.
STEP 8) Place the Deck Covers (#9) into the open portion of the Track Assembly. They are approximately 6" x 36" or
48" and have a ribbed safety vinyl laminated to the surface.
End View
End view of Front Unit
End view of Rear Unit
10
11
22
2